Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
75056B
1.REMOVE REAR OUTER PILLAR GARNISH SUB-ASSEMBLY
When removing the rear outer pillar garnish sub-assembly, heat the vehicle body and rear outer pillar garnish sub-assembly using a heat light.
| Item | Temperature |
|---|---|
| Vehicle Body | 40 to 60°C (104 to 140°F) |
| Rear Outer Pillar Garnish Sub-assembly | 20 to 30°C (68 to 86°F) |
Do not heat the vehicle body, rear outer pillar garnish sub-assembly excessively.
|
Protective Tape |
Apply protective tape around the rear outer pillar garnish sub-assembly as shown in the illustration.
Disengage the 6 clips and remove the rear outer pillar garnish sub-assembly.