Home › Vehicle Exterior › DOOR / HATCH › LUGGAGE COMPARTMENT DOOR › from 2015.04
RM19V0EQ _59 Vehicle Exterior _014618 DOOR / HATCH _0074224 LUGGAGE COMPARTMENT DOOR N

DOOR / HATCH  LUGGAGE COMPARTMENT DOOR  ADJUSTMENT  


CAUTION / NOTICE / HINT

B280558C05
2.458,0.167 2.844,0.479 0.385,0.313 10 false *2 0.792,0.167 1.146,0.479 0.354,0.313 10 false *1
*1 Centering Bolt
*2 Standard Bolt


HINT:
·

Centering bolts are used to mount the door hinge to the door. The door cannot be adjusted with the centering bolts installed. Substitute the centering bolts with standard bolts when making adjustments.

·

Specified torque for standard bolts is shown in the standard bolt chart.

Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS



PROCEDURE

Hide 64719A 1.REMOVE LUGGAGE COMPARTMENT DOOR COVER

Hide 64711 2.REMOVE LUGGAGE COMPARTMENT FLOOR MAT

Hide 58387 3.REMOVE REAR FLOOR FINISH PLATE

Hide 4.ADJUST LUGGAGE COMPARTMENT DOOR

a.
B280559

Loosen the door side hinge bolts to adjust the door horizontally and vertically.

Torque:
7.5 N*m (77 kgf*cm, 66 in.*lbf)


b.
B280560

Using a T40 "TORX" socket wrench, slightly loosen the striker mounting screws.


c.

Using a brass bar and a hammer, hit the striker to adjust its position.


d.

Using a T40 "TORX" socket wrench, tighten the striker mounting screws after adjustment.

Torque:
23 N*m (235 kgf*cm, 17 ft.*lbf)


Hide 58387 5.INSTALL REAR FLOOR FINISH PLATE

Hide 64711 6.INSTALL LUGGAGE COMPARTMENT FLOOR MAT

Hide 64719A 7.INSTALL LUGGAGE COMPARTMENT DOOR COVER

Hide 8.INSPECT LUGGAGE COMPARTMENT DOOR

a.

Check that the clearance measurements of areas a through d are within each standard range.

B400621N01
1.167,0.99 1.323,1.188 0.156,0.198 10 false a 2.667,0.865 2.823,1.063 0.156,0.198 10 false b 2.99,1.698 3.146,1.896 0.156,0.198 10 false c 6.125,1.406 6.281,1.604 0.156,0.198 10 false d

Standard Clearance
Area Measurement Area Measurement
a 6.3 mm (0.248 in.) b 2.3 to 5.3 mm (0.0906 to 0.209 in.)
c 1.2 to 1.8 mm (0.0472 to 0.0709 in.) d 6.2 mm (0.244 in.)