Home › Vehicle Interior › PRE-CRASH SAFETY › PRE-CRASH SAFETY SYSTEM WARNING BUZZER › from 2015.04
RM19V0EQ _58 Vehicle Interior _034909 PRE-CRASH SAFETY _0166367 PRE-CRASH SAFETY SYSTEM WARNING BUZZER G

PRE-CRASH SAFETY  PRE-CRASH SAFETY SYSTEM WARNING BUZZER  INSPECTION  


PROCEDURE

Hide 86652B 1.INSPECT SKID CONTROL BUZZER

a.
E315531

Make sure that there is no looseness at the locking part and the connecting part of the connector.


b.

Disconnect the skid control buzzer connector.


c.

Check both the connector case and the terminal for deformation and corrosion.

OK:

No deformation or corrosion.



d.

Connect a negative (-) lead from the battery to terminal 1, and a positive (+) lead to terminal 2 of the skid control buzzer, and then check that the buzzer sounds.

OK:

The skid control buzzer sounds.


If the result is not as specified, replace the skid control buzzer.