Home › Engine / Hybrid System › 2AR-FE ENGINE CONTROL › CRANKSHAFT POSITION SENSOR › from 2015.04
RM19V0EQ _51 Engine / Hybrid System _014573 2AR-FE ENGINE CONTROL _0073918 CRANKSHAFT POSITION SENSOR A

2AR-FE ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  INSTALLATION  


PROCEDURE

Hide 11301K 1.INSTALL CRANKSHAFT POSITION SENSOR

a.
A157503C11
1.813,0.844 2,0.427 2,0.427 2.24,0.427 false 2.313,0.333 2.531,0.573 0.219,0.24 10 false *a
*a O-ring


Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.

NOTICE:

If reusing the crankshaft position sensor, be sure to inspect the O-ring.



b.

Install the crankshaft position sensor to the timing chain cover sub-assembly with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:
·

If the crankshaft position sensor has been struck or dropped, replace it.

·

Make sure that the O-ring is not cracked or moved out of place when installing the crankshaft position sensor.




c.

Connect the crankshaft position sensor connector.


Hide 2.INSPECT FOR OIL LEAK