Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM(w/o Smart Entry and Start System) › from 2015.04
RM19V0EQ _58 Vehicle Interior _014606 THEFT DETERRENT / KEYLESS ENTRY _0074131 ENGINE IMMOBILISER SYSTEM(w/o Smart Entry and Start System) J

THEFT DETERRENT / KEYLESS ENTRY  ENGINE IMMOBILISER SYSTEM(w/o Smart Entry and Start System)  ECU Power Source Circuit  


DESCRIPTION

This circuit provides power to operate the transponder key ECU assembly.

WIRING DIAGRAM

B260651E06
4.771,2.844 6.896,3.031 2.125,0.188 10 false Transponder Key ECU Assembly 4.771,2.656 5.073,2.844 0.302,0.188 10 false I19 5.51,1.906 5.854,2.094 0.344,0.188 10 false GND 5.51,1.375 5.854,1.563 0.344,0.188 10 false IG 5.51,0.75 5.854,0.938 0.344,0.188 10 false +B 5.323,0.635 5.469,0.823 0.146,0.188 10 false 1 5.323,1.25 5.469,1.438 0.146,0.188 10 false 2 5.313,1.813 5.521,2 0.208,0.188 10 false 5 3,1.542 4.063,1.729 1.063,0.188 10 false ECU-IG2 NO. 2 3.063,0.938 3.948,1.125 0.885,0.188 10 false ECU-B NO. 1 1.292,0.729 2.115,0.917 0.823,0.188 10 false from Battery 0.688,1.365 2.146,1.75 1.458,0.385 10 false from Ignition or Starter Switch Assembly

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - BATTERY AND BODY GROUND)
a.

Disconnect the transponder key ECU assembly connector.


b.

Measure the voltage and resistance according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
I19-1 (+B) - Body ground Always 11 to 14 V
I19-2 (IG) - Body ground Ignition switch off Below 1 V
I19-2 (IG) - Body ground Ignition switch ON 11 to 14 V


Standard Resistance:
Tester Connection Condition Specified Condition
I19-5 (GND) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR