44510
1.INSTALL BRAKE ACTUATOR ASSEMBLY
Install the brake actuator assembly to the brake actuator bracket assembly.
Do not remove the hole plugs of a new brake actuator assembly before connecting the brake lines because the brake actuator assembly is filled with brake fluid.
Do not hold the brake actuator assembly by the connector.
Tighten the 3 nuts.
Tighten the 3 nuts in the order shown in the illustration.
2.INSTALL BRAKE ACTUATOR WITH BRACKET
Install the brake actuator with bracket to the vehicle body with the 3 bolts.
Do not damage the brake lines, suction hose sub-assembly or wire harness.
Tighten the 3 bolts in the order shown in the illustration.
| *a | From 1st Chamber of Master Cylinder Sub-assembly |
| *b | From 2nd Chamber of Master Cylinder Sub-assembly |
| *c | To Front Wheel Cylinder Assembly LH |
| *d | To Rear Wheel Cylinder Assembly RH |
| *e | To Rear Wheel Cylinder Assembly LH |
| *f | To Front Wheel Cylinder Assembly RH |
Temporarily tighten each brake line to the correct position on the brake actuator assembly as shown in the illustration.
Using a union nut wrench, fully tighten each brake line.
Use the formula to calculate special torque values for situations where the union nut wrench is combined with a torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
Connect the connector to the brake actuator assembly and disengage the claw (b).
Put the lever down and engage the claw (a) to engage the connector lock.
Make sure that the connector is locked securely.
Make sure that the actuator connector can be connected smoothly. Do not allow water, oil or dirt to enter.
3.INSTALL SUCTION PIPE CLAMP
Engage the suction pipe clamp to install it to the brake actuator bracket assembly.
4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
5.BLEED BRAKE SYSTEM
6.INSPECT BRAKE ACTUATOR USING INTELLIGENT TESTER
7. PERFORM SYSTEM VARIANT LEARNING
8. CHECK FOR AND CLEAR DTCS