82142A
1.INSTALL NO. 2 INSTRUMENT PANEL WIRE
| *1 | Airbag Connector |
| *2 | Airbag Connector Lock |
Connect the airbag connector of the No. 2 instrument panel wire to the instrument panel passenger airbag assembly.
When connecting any airbag connector, take care not to damage the airbag wire harness.
Push in the lock to install the airbag connector to the instrument panel passenger airbag assembly.
Engage the clamp.
73960A
2.INSTALL INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY
If the hooks are not engaged in the correct order, the deployment part of the instrument panel passenger airbag assembly may be damaged.
Engage the 3 hooks as shown in the illustration.
Push the instrument panel passenger airbag assembly to engage the 3 hooks.
Install the 2 screws to install the instrument panel passenger airbag assembly.
3.INSTALL INSTRUMENT PANEL SAFETY PAD ASSEMBLY
82142A
4.CONNECT NO. 2 INSTRUMENT PANEL WIRE
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
Connect the connector.
When connecting any airbag connector, take care not to damage the airbag wire harness.
55011A
5.INSTALL NO. 1 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY
6. PERFORM DIAGNOSTIC SYSTEM CHECK