The power steering ECU assembly receives vehicle speed signals from the brake actuator assembly via CAN communication. The ECU provides appropriate assisting force in accordance with the vehicle speed based on the signals.
If the ECU detects this DTC, it adjusts the amount of power assistance for a speed of 140 km/h (87 mph) and continues system control.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Warning Indicate | Return-to-normal Condition |
|---|---|---|---|---|---|
| C1541/13 | Vehicle Speed Signal | This DTC is detected when vehicle speed signals via CAN communication are cut off for 3 seconds or more. | ·
Speed sensor circuit ·
Brake actuator assembly ·
CAN communication system ·
Power steering ECU assembly |
EPS Warning Light: Comes on | Ignition switch ON again |
If the power steering ECU assembly has been replaced, perform assist map writing (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION).
Check if DTC U0129/42 is output.
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM
| Result | Proceed to |
|---|---|
| U0129/42 is not output. | A |
| U0129/42 is output. | B |
DTC U0129/42 indicates a brake actuator assembly communication malfunction in the power steering system.
A
B
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Check for brake control system DTCs.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR
Vehicle stability control system DTCs are not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG