Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM › from 2016.05
RM19V0EQ _53 Suspension _052591 TIRE PRESSURE MONITORING _0265587 TIRE PRESSURE WARNING SYSTEM C

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING SYSTEM  C2177/77  Initialization not Completed  


DESCRIPTION

Initialization is necessary if one of the following occurs:

·

The tire pressure warning ECU and receiver is replaced.

·

A tire pressure warning valve and transmitter is replaced.

·

Tires with different standard tire pressures are installed.

·

The tires are rotated.

·

A new vehicle is delivered.


DTC No. Detection Item DTC Detection Condition Trouble Area Note
C2177/77 Initialization not Completed All conditions below are met:
·

During initialization

·

Tire pressure warning valve and transmitter is not in stop mode

·

Signal is not received from tire pressure warning valve and transmitter for 20 minutes or more

·

Vehicle speed is more than 40 km/h (25 mph) for 20 minutes or more


·

Tire pressure warning valve and transmitter

·

Wire harness or connector

·

Tire pressure warning ECU and receiver


-

WIRING DIAGRAM

C269188E08
5.979,3.875 6.604,4.198 0.625,0.323 10 false RDA2 5.979,4.354 6.677,4.719 0.698,0.365 10 false PRG2 4.302,3.854 4.646,4.021 0.344,0.167 10 false RDA 4.302,4.302 4.646,4.469 0.344,0.167 10 false PRG 5.99,6.49 6.469,6.656 0.479,0.167 10 false CLSW 5.781,6.375 5.927,6.542 0.146,0.167 10 false 3 6,7.042 6.479,7.208 0.479,0.167 10 false GND 5.719,6.938 5.948,7.104 0.229,0.167 10 false 12 2.385,6.417 2.531,6.583 0.146,0.167 10 false 6 3.542,6.417 3.708,6.583 0.167,0.167 10 false 9 5.771,4.208 5.938,4.375 0.167,0.167 10 false 5 5.771,3.75 5.958,3.917 0.188,0.167 10 false 4 5.729,7.823 7.135,8.354 1.406,0.531 10 false Tire Pressure Warning ECU and Receiver 1.906,6.99 4.25,7.25 2.344,0.26 10 false Tire Pressure Warning Reset Switch 5.729,7.635 6.594,7.802 0.865,0.167 10 false N44 2.802,0.385 4.906,0.74 2.104,0.354 10 false Tire Pressure Warning Valve and Transmitter 0.292,1.01 2.396,1.365 2.104,0.354 10 false Tire Pressure Warning Valve and Transmitter 2.813,1.667 4.906,2.021 2.094,0.354 10 false Tire Pressure Warning Valve and Transmitter 0.302,2.333 2.302,2.75 2,0.417 10 false Tire Pressure Warning Valve and Transmitter 0.604,7.354 1.688,7.573 1.083,0.219 10 false : Radio Waves 0.563,7.698 2.406,7.917 1.844,0.219 10 false : CAN Communication Line 3.052,5.917 3.5,6.083 0.448,0.167 10 false DLC3 2.313,4.875 4.333,5.042 2.021,0.167 10 false Combination Meter Assembly 2.292,5.177 4.271,5.563 1.979,0.385 10 false - Tire Pressure Warning Light 2.5,3.833 4.167,4.5 1.667,0.667 10 false Main Body ECU (Multiplex Network Body ECU) 4.708,3.76 4.979,3.927 0.271,0.167 10 false 16 4.729,4.208 4.917,4.375 0.188,0.167 10 false 4 2.25,3.833 2.521,4.031 0.271,0.198 10 false I13 1.906,6.792 2.271,6.969 0.365,0.177 10 false I197 2.781,3.031 4.875,3.385 2.094,0.354 10 false Tire Pressure Warning Valve and Transmitter 2.656,6.458 2.99,6.708 0.333,0.25 10 false E 3.229,6.448 3.563,6.781 0.333,0.333 10 false INT

CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the GTS and write them down before removal.

·

It is necessary to perform initializationSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>INITIALIZATION after registrationSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>REGISTRATION of the transmitter IDs into the tire pressure warning ECU and receiver if the ECU and/or one of the valve and transmitters has been replaced.



PROCEDURE

1.CHECK FREQUENCY RECEIVING CONDITION
a.

Check that the following conditions are not met:

i.

Facilities or devices that use similar radio frequencies are located in the vicinity of the vehicle.

HINT:

If the vehicle is located in an area such as the one described above, the tire pressure warning light may illuminate after blinking 1 minute due to interfering radio frequencies.



ii.

Devices using similar radio frequencies are used in the vehicle.

OK:

Facilities or devices that use similar radio frequencies are not located in the vicinity of the vehicle.


HINT:

Radio transmissions may be interrupted due to the surroundings, or devices installed by the user.




Result:
Proceed to
OK
NG



OK

2.PERFORM INITIALIZATION

NG

CHECK IF ANY DEVICE IS INSTALLED BY USER

2.PERFORM INITIALIZATION

Result:
Proceed to
NEXT



NEXT

3.CONFIRM TIRE INFLATION PRESSURE (DATA LIST)
3.CONFIRM TIRE INFLATION PRESSURE (DATA LIST)
a.

Turn the ignition switch off.


b.

Connect the GTS to the DLC3.


c.

Turn the ignition switch to ON.


d.

Turn the GTS on.


e.

Enter the following menus: Chassis / Tire Pressure Monitor / Data List.


f.

Check the values by referring to the table below.

Chassis > Tire Pressure Monitor > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
ID 1 Tire Inflation Pressure ID1 tire inflation pressure min.: Absolute pressure (abs) / 0 kPa (0 kgf/cm2, 0 psi), Relative pressure (Gauge) / 0 kPa (0 kgf/cm2, 0 psi)
max.: Absolute pressure (abs) / 480 kPa (4.9 kgf/cm2, 70 psi), Relative pressure (Gauge) / 380 kPa (3.9 kgf/cm2, 55 psi)
Actual tire inflation pressure If N/A is displayed, data has not been received.*1
ID 2 Tire Inflation Pressure ID2 tire inflation pressure min.: Absolute pressure (abs) / 0 kPa (0 kgf/cm2, 0 psi), Relative pressure (Gauge) / 0 kPa (0 kgf/cm2, 0 psi)
max.: Absolute pressure (abs) / 480 kPa (4.9 kgf/cm2, 70 psi), Relative pressure (Gauge) / 380 kPa (3.9 kgf/cm2, 55 psi)
Actual tire inflation pressure If N/A is displayed, data has not been received.*1
ID 3 Tire Inflation Pressure ID3 tire inflation pressure min.: Absolute pressure (abs) / 0 kPa (0 kgf/cm2, 0 psi), Relative pressure (Gauge) / 0 kPa (0 kgf/cm2, 0 psi)
max.: Absolute pressure (abs) / 480 kPa (4.9 kgf/cm2, 70 psi), Relative pressure (Gauge) / 380 kPa (3.9 kgf/cm2, 55 psi)
Actual tire inflation pressure If N/A is displayed, data has not been received.*1
ID 4 Tire Inflation Pressure ID4 tire inflation pressure min.: Absolute pressure (abs) / 0 kPa (0 kgf/cm2, 0 psi), Relative pressure (Gauge) / 0 kPa (0 kgf/cm2, 0 psi)
max.: Absolute pressure (abs) / 480 kPa (4.9 kgf/cm2, 70 psi), Relative pressure (Gauge) / 380 kPa (3.9 kgf/cm2, 55 psi)
Actual tire inflation pressure If N/A is displayed, data has not been received.*1
ID 5 Tire Inflation Pressure ID5 tire inflation pressure min.: Absolute pressure (abs) / 0 kPa (0 kgf/cm2, 0 psi), Relative pressure (Gauge) / 0 kPa (0 kgf/cm2, 0 psi)
max.: Absolute pressure (abs) / 480 kPa (4.9 kgf/cm2, 70 psi), Relative pressure (Gauge) / 380 kPa (3.9 kgf/cm2, 55 psi)
Actual tire inflation pressure If N/A is displayed, data has not been received.*1
Chassis > Tire Pressure Monitor > Data List
Tester Display
ID 1 Tire Inflation Pressure
ID 2 Tire Inflation Pressure
ID 3 Tire Inflation Pressure
ID 4 Tire Inflation Pressure
ID 5 Tire Inflation Pressure
50003 203 36,37,38,39,40
HINT:
·

*1: It may take a few minutes until the values are displayed.

·

When an "ID Tire Inflation Pressure" value has not changed, reset the tire pressure to the appropriate specified value and rotate the tire 90 to 270 degrees. Then rapidly release the tire pressure and recheck the value.




Result:
Result Proceed to
All tire pressure readings are equal to specified values. A
Tire pressure values are not displayed. B



A

END

B