1. PRECAUTION
Be sure to read Precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(w/ VSC)>PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
33525
3.REMOVE SHIFT LEVER SUPPORT
58543B
4.REMOVE FLOOR CARPET BRACKET RH
89170
5.REMOVE AIRBAG SENSOR ASSEMBLY
46441
6.LOOSEN ADJUSTING NUT
| *1 | Lock Nut |
| *2 | Adjusting Nut |
Remove the lock nut and loosen the adjusting nut.
46440
7.SEPARATE NO. 4 PARKING BRAKE CABLE ASSEMBLY
| *a | Turn |
| *b | Hold |
Separate the No. 4 parking brake cable assembly from the parking brake control pedal assembly as shown in the illustration.
46201
8.REMOVE PARKING BRAKE CONTROL PEDAL ASSEMBLY
Turn back the floor carpet.
Remove the clip from the No. 1 parking brake cable assembly.
Remove the bolt and 2 nuts, and separate the No. 1 parking brake cable assembly.
Disconnect the parking brake switch connector.
Remove the bolt, 2 nuts and parking brake control pedal assembly.