REAR FLOOR PAN > ASSEMBLY REPLACEMENT



  1. K101340
    With the rear floor rear inner crossmember removed.

REMOVAL

Symbol meaning
K100014
Remove Weld Points
K100015
Remove Weld Points
K100016
Remove Weld Points

K101341E01


K101342E01


K101343E01


INSTALLATION

Symbol meaning
K100019
Plug Weld
K100020
Plug Weld
K100021
Plug Weld
K100026
Fillet Weld
INSTALLATION POINT
  1. Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimension diagram)
  2. Before temporarily installing the new parts, weld the spare wheel clamp bracket, rear floor pan reinforcement, fuel tube bracket No. 3 and weld bolts with the standard number of welding points.
  3. When welding *1, make a hole on a new part for plug welding and weld the panel with the panel behind completely.
  4. After welding, apply body sealer and undercoating to the corresponding parts. (See the painting / coating)
  5. After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.

K101344E01


K101345E01


K101346E01


K101347E01