CENTER BODY PILLAR > CUT AND JOIN REPLACEMENT SECTIONS


K101289

REMOVAL

Symbol meaning
K100014
Remove Weld Points
K100022
Cut with Disk Sander etc.
K100023
Cut and Join Location
K100024
Cut Location for Supply Parts
REMOVAL POINT
  1. *1 is reused.

K101290E01


INSTALLATION

Symbol meaning
K100019
Plug Weld
K100023
Cut and Join Location
K100027
Butt Weld
INSTALLATION POINT
  1. Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.
  2. Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)
  3. If the entire supply part is not needed, remove the part of the supply part that is needed.
  4. Before temporarily installing the new parts, weld the center body pillar reinforce upper and center body pillar inner with the standard number of welding points.
  5. After welding the center body pillar reinforce upper and center body pillar inner to the vehicle side, install the rocker panel outer and *1.
  6. After welding, apply the foamed sealing material to the corresponding parts. (See the painting / coating)
  7. After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.

K101291E01


K101292E01


K101293E01