ROCKER REAR PANEL > CUT AND JOIN REPLACEMENT SECTIONS



  1. K101307
    With the Quarter Panel removed.

REMOVAL

Symbol meaning
K100014
Remove Weld Points
K100023
Cut with Disc Sander etc.
K100024
Cut Location for Supply Parts
REMOVAL POINT
  1. *1 is reused.

K101308E01


INSTALLATION

Symbol meaning
K100019
Plug Weld
K100021
Plug Weld
K100027
Butt Weld
K100030
Body Sealer
INSTALLATION POINT
  1. If the entire supply part is not needed, remove the part of the supply part that is needed.
  2. Before temporarily installing the new parts, weld the center body pillar reinforce lower, rocker extension outer and rocker panel reinforcement with the standard number of welding points.
  3. After welding the center body pillar reinforce lower, rocker extension outer and rocker panel reinforcement to the vehicle side, install the *1.
  4. After welding, apply body sealer to the corresponding parts. (See the painting / coating)
  5. After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.

K101309E01


K101310E01