ENGINE UNIT > GENERAL



OUTLINE


  1. The 1AZ-FE engine is an in-line 4-cylinder, 2.0 liter, 16 valve DOHC engine. This engine uses the Variable Valve Timing-intelligent (VVT-i) system, Direct Ignition System (DIS) and Electronic Throttle Control System-intelligent (ETCS-i). These control functions achieve improved engine performance, fuel economy, and clean emissions.


    W105652


SPECIFICATION

Engine Type
1AZ-FE
No. of Cyls. & Arrangement
4-cylinder, In-line
Valve Mechanism
16-valve DOHC, Chain Drive
(With VVT-i)
Combustion Chamber
Pentroof Type
Flow of Intake and Exhaust Gasses
Cross-flow
Fuel System
SFI
Ignition System
DIS
Displacement
cm3 (cu. in.)
1998 (121.9)
Bore X Stroke
mm (in.)
86.0 X 86.0 (3.39 X 3.39)
Compression Ratio
9.8 : 1
Max. Output (EEC)
kW@rpm
109@6000
Max. Torque (EEC)
N*m@rpm
190@4000
Oil Capacity
Dry
liters (US qts, Imp. qts)
5.0 (5.3, 4.4)
With Oil Filter
liters (US qts, Imp. qts)
4.3 (4.5, 3.8)
Without Oil Filter
liters (US qts, Imp. qts)
4.1 (4.3, 3.6)
Oil Grade
API grade SL "Energy-Conserving", SM "Energy-Conserving", SN "Resource-Conserving" or ILSAC multigrade engine oil
Engine Coolant
Type
TOYOTA Genuine Super Long Life
Coolant or the following*1
Capacity
liters (US qts, Imp. qts)
6.6 (7.0, 5.8)
Spark Plug
Type
DENSO Made
SK16R11 (Iridium)
NGK Made
IFR5A11 (Iridium)
Plug Gap
mm (in.)
1.0 to 1.1 (0.0394 to 0.0433)
Firing Order
1 - 3 - 4 - 2
Fuel Octane Number
91 or higher
Emission Regulation
EURO IV
Engine Service Mass*2 (Reference)
kg (lb)
130 (287)
  1. *1: Similar high quality ethylene glycol based non-silicate, non-amine, non-nitrite, and non-borate coolant with long-life hybrid organic acid technology. (Coolant with long-life hybrid organic acid technology consists of a combination of low phosphates and organic acids.)
  2. *2: The figure shown is the weight of the part without coolant and oil.

W105885E01


MAIN FEATURES
  1. The 1AZ-FE engine has achieved the following performance through the use of the items listed in the table below.

    1. High performance and reliability

    2. Low noise and vibration

    3. Lightweight and compact design

    4. Good serviceability

    5. Clean emissions and fuel economy

      Item
      (1)
      (2)
      (3)
      (4)
      (5)
      Engine Proper
      A cylinder head cover sub-assembly made of aluminum alloy is used.


      ○


      A taper squish shape is used for combustion chambers.
      ○



      ○
      Spiny-type liners are used in the cylinder bores.
      ○




      A water jacket spacer is used.
      ○



      ○
      The piston skirt is coated with resin.
      ○
      ○


      ○
      A resin gear balance shaft is used.

      ○
      ○


      Valve Mechanism
      The Variable Valve Timing-intelligent (VVT-i) system is used.
      ○



      ○
      A chain sub-assembly and No. 1 chain tensioner assembly are used.

      ○

      ○

      Cooling System
      TOYOTA Genuine Super Long Life Coolant (SLLC) is used.



      ○

      Intake and Exhaust System
      An intake manifold made of plastic is used.


      ○


      A linkless type throttle body with motor assembly is used.


      ○
      ○

      A stainless steel exhaust manifold sub-assembly is used.


      ○

      ○
      An ultra thin-wall, high-cell density ceramic type Three-Way Catalytic converter (TWC) is used.




      ○
      Fuel System
      A fuel returnless system is used.


      ○
      ○
      ○
      Quick connectors are used to connect the fuel hoses with the fuel pipes.



      ○

      Compact 12-hole type fuel injector assemblies are used.
      ○



      ○
      Ignition System
      The Direct Ignition System (DIS) is used.
      ○

      ○
      ○
      ○
      Iridium-tipped spark plugs are used.
      ○


      ○
      ○
      Charging System
      A segment conductor type generator assembly is used.
      ○

      ○


      Starting System
      A planetary reduction type starter assembly is used.


      ○


      Serpentine Belt Drive System
      A serpentine belt drive system is used.


      ○
      ○

      Engine Control System
      A Magnet Pick Up (MPU) type camshaft position sensor is used.
      ○



      ○
      The Electronic Throttle Control System-intelligent (ETCS-i) is used.
      ○



      ○
      An evaporative emission control system is used.




      ○