POWER WINDOW CONTROL SYSTEM > DETAILS |
| SYSTEM CONTROL |
The power window control system has the following functions:
| Function | Outline | Customizable*1 |
| Power Up-and-down (All Doors) | This function causes the window to open or close while the multiplex network master switch assembly or power window regulator switch assembly is being pulled halfway up or pushed halfway down. The window stops as soon as the switch is released. | Standard (Not Customizable) |
| One-touch Auto Up-and-down (All Doors) | The one-touch auto up-and-down function enables the window to be fully opened or closed at a touch of the multiplex network master switch assembly. | Standard (Not Customizable) |
| Jam Protection (All Doors) | The jam protection function automatically stops the power window and moves it downward if a foreign object gets jammed in the window during one-touch auto-up operation or power up operation. | Standard (Not Customizable) |
| Remote Control (All Doors) | The multiplex network master switch assembly can control the up-and-down operation of the windows. | Standard (Not Customizable) |
| Window Lock |
| Standard (Not Customizable) |
| Key Off Operation |
| Standard (Not Customizable) |
| Key-linked Up-and-down | When the electrical key transmitter sub-assembly is not in the interior detection area*3, the driver door is locked, and the door control transmitter assembly*4 or mechanical key*3 in the driver door is turned and maintained in the lock direction for 1.5 seconds or more, the main body ECU (multiplex network body ECU) activates the power window motors to raise all door windows while the door control transmitter assembly*4 or mechanical key*3 is turned. Similarly, when the driver door is unlocked, turning and maintaining the driver door key cylinder in the unlock direction for 1.5 seconds or more will cause all door windows to be lowered. | *2 |
| Transmitter-linked Down | When the certification ECU (smart key ECU assembly) receives an unlock signal from the transmitter for longer than 3 seconds, the main body ECU (multiplex network body ECU) controls their power window motors in accordance with the signal to open the windows. | *2 |
Jam Protection Function
The jam protection function automatically stops the power window and moves it downward if a foreign object gets jammed in the door window during one-touch auto up operation or power up operation.
The operation of the jam protection function is described below.
| Door Window Position from Full Close | Operation |
| 200 mm (7.87 in.) or more | Down operation of 125 mm (4.93 in.) or 2.5 seconds |
| 200 mm (7.87 in.) or less | Down operation until door window downward movement of 200 mm (7.87 in.) is reached, or 5 seconds elapses. |
The magnet and Hall IC in the power window motor are used to enable power window jam protection.

| *1 | Hall IC | *2 | Worm Gear |
| *3 | Magnet | - | - |
The Hall IC converts the changes in the magnetic flux that occur through the rotation of the magnet into pulse signals and outputs them to the ECU built-into the power window motor.
To control the jam protection function, the ECU determines the amount of movement and jamming of the window glass based on the pulse signal A from the Hall IC; and judges the direction of the window glass movement based on the phase difference between the pulses from Hall IC signals A and B.

| FAIL-SAFE |
If the Hall IC in the power window motor (driver) malfunctions, some power window functions will be prohibited for fail-safe mode:
The power window operates when the power window switch is fully pushed down or pulled up and held in that position.
| DIAGNOSIS |
When the power window ECU detects the following condition, it switches to fail-safe mode.
An abnormality in the Hall IC that detects the position, speed and direction of the window.