SLIDING ROOF SYSTEM > GENERAL



OUTLINE
  1. The sliding roof system uses a glass panel to perform tilt up-and-down and open-and-close operations.

  2. The sliding roof ECU controls the sliding roof system. This ECU uses 2 Hall ICs to detect the position of the sliding roof. The sliding roof ECU and the 2 Hall ICs are integrated in the sliding roof drive gear sub-assembly.


PRECAUTION
  1. The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section.

    Expression
    Ignition Switch
    (Position)
    Engine Switch
    (Condition)
    Ignition Switch off
    LOCK
    Off
    Ignition Switch ACC
    ACC
    On (ACC)
    Ignition Switch ON
    ON
    On (IG)
    Engine Start
    START
    Start