LIGHTING SYSTEM > GENERAL



OUTLINE


  1. Exterior Lights



    1. The exterior lights consist of the following:


      Y111652E01


      Text in Illustration 
      *1
      Side Turn Signal Light RH
      *2
      Side Turn Signal Light LH
      *3
      Headlight Assembly RH
      *4
      Fog Light Assembly RH
      *5
      Fog Light Assembly LH
      *6
      Headlight Assembly LH
      *7
      Front Turn Signal Light
      *8
      Clearance Light
      *9
      High Beam
      *10
      Low Beam

      Y111653E01


      Text in Illustration 
      *A
      Models with Rear Fog Light
      -
      -
      *1
      High Mounted Stop Light (Center Stop Light Set)
      *2
      Rear Combination Light Assembly LH
      *3
      Rear Combination Light Assembly RH
      *4
      Rear Light Assembly LH
      *5
      License Plate Light
      *6
      Rear Light Assembly RH
      *7
      Back-up Light
      *8
      Rear Fog Light
      *9
      Tail Light
      *10
      Rear Turn Signal Light
      *11
      Taillight and Stop Light
      -
      -

  2. High Intensity Discharge (HID) Headlight System

    1. The HID headlight system uses a metal halide bulb as the light source for each low beam. Discharge bulbs are superior to halogen bulbs.



  3. Intelligent Adaptive Front-lighting System (AFS)



    1. An intelligent Adaptive Front-lighting System (AFS) is used in order to ensure a wide range of low beam lighting area and realize excellent visibility during turning by moving the low beams to the inside of the cornering direction.


      Y103342E04


      Text in Illustration 
      *A
      Models with Intelligent AFS
      *B
      Models without Intelligent AFS

  4. Automatic Headlight Beam Level Control System

    1. When the headlights are on, the automatic headlight beam level control system operates the headlight leveling motors in accordance with movement of the vehicle.

  5. Manual Headlight Beam Level Control System

    1. When the vehicle posture changes in accordance with the number (weight) of passengers and volume of luggage, this system makes it possible to adjust the low beam level (5-steps) manually to the appropriate level. The low beam level is adjusted using the headlight beam level control switch.

  6. Automatic Light Control System

    1. When the dimmer switch is in the AUTO position, the light control sensor detects the ambient light level and automatically turns the headlights, taillights, parking lights and license plate lights on or off accordingly.

    2. This system is controlled by the main body ECU (multiplex network body ECU).

  7. Light Auto Turn-off System

    1. The light auto turn-off system is used to prevent the driver from leaving the vehicle with the headlights, front fog lights, parking lights, taillights or license plate lights on.


SPECIFICATION

Light
Type
Wattage
Headlight Assembly
Halogen Headlight
High Beams
Halogen Bulb
60
Low Beams
Halogen Bulb
55
Front Turn Signal Lights
Bulb
21
Clearance Light
Bulb
5
HID Headlight
High Beams
Halogen Bulb
60
Low Beams
Discharge Bulb
35
Front Turn Signal Lights
Bulb
21
Clearance Light
Bulb
5
Side Turn Signal Light Assembly (LH, RH)
Bulb
5
Front Fog Light Assembly
Halogen Bulb
55
Rear Light Assembly
Backup Lights
Bulb
16
Tail Lights
Bulb
5
Rear Fog Lights*
Bulb
21
Rear Combination Light Assembly
Tail Lights/Stop Lights
Bulb
21/5
Turn Signal Lights
Bulb
21
Backup Light
Bulb
16
High Mounted Stop Light (Center Stop Light Set)
LED x 4
0.8
License Plate Lights
Bulb
5
  1. *: Models with rear fog lights

MAJOR DIFFERENCE
  1. The new models have been modified from the previous models as shown below:

    1. The separate type yawrate sensor has been discontinued.


MAIN FEATURES
  1. High Intensity Discharge (HID) Headlight System

    1. The light emitted by the bulb is close in color to sunlight. The light shines ahead over a broader area and farther forward, increasing the area visible to the driver.

    2. Less power is consumed compared to halogen headlights.


PRECAUTION
  1. High Intensity Discharge (HID) Headlight System

    1. When the HID headlights illuminate, a high voltage (approximately 30000 V) is applied momentarily to the bulb sockets. Never connect a tester to the high voltage socket of a HID headlight for measurement, as this may lead to a serious accident because of high voltage.

    2. Whenever inspecting the HID headlight system, make sure that water or rain is not present, the dimmer switch is off, the battery terminal is disconnected, and the connector of the light control ECU is disconnected in order to prevent an electric shock.

    3. Whenever operating the HID headlights, make sure that it is done only after assembly has been completed and never operate the system without bulbs installed.

    4. Do not operate the HID headlights using a power source other than the vehicle's.

    5. When there is a defect in an HID headlight or any shock has been applied to it, replace the bulb with a new one.

    6. A discharge bulb reaches a high temperature when it is illuminated. For this reason, the life of the bulb could be shortened if any oil comes in contact with the glass portion of the bulb. Do not touch the glass portion of a bulb with bare hands.

  2. Ignition Switch Expressions

    1. The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section.

      Expression
      Ignition Switch
      (Position)
      Engine Switch
      (Condition)
      Ignition Switch off
      LOCK
      Off
      Ignition Switch ACC
      ACC
      On (ACC)
      Ignition Switch ON
      ON
      On (IG)
      Engine Start
      START
      Start