DRIVE SHAFT SYSTEM > GENERAL |
| OUTLINE |
The front drive shaft assembly for all models uses a tripod type Constant Velocity (CV) joint on the differential side, and a Rzeppa type CV joint on the wheel side.

| *A | Models with 1AZ-FE Engine | *B | Models with 2AR-FE Engine |
| *C | Models with 2GR-FE Engine | - | - |
| *1 | Rzeppa Type CV Joint | *2 | Tripod Type CV Joint |
| *3 | Front Drive Shaft Assembly LH | *4 | Front Drive Shaft Assembly RH |
![]() | Wheel Side | ![]() | Differential Side |
| MAJOR DIFFERENCE |
The new models have been modified from the previous models as shown below:
Due to the addition of the 1AZ-FE engine, front drive shaft assemblies for models with the 1AZ-FE engine have been added.