Home › Engine / Hybrid System ยท 1AZ-FE › INTAKE / EXHAUST › EXHAUST PIPE

EXHAUST PIPE > REMOVAL

for Preparation Click here



1. REMOVE HEATED OXYGEN SENSOR
(Click here)


2. REMOVE TAIL EXHAUST PIPE ASSEMBLY


    A261041
  1. Remove the 2 bolts and 2 compression springs.

  1. Remove the tail exhaust pipe assembly from the 3 exhaust pipe supports.

  1. Remove the gasket from the center exhaust pipe assembly.



3. REMOVE CENTER EXHAUST PIPE ASSEMBLY


    A254706
  1. Remove the 2 nuts.

  1. Remove the center exhaust pipe assembly from the exhaust pipe support.

  1. Remove the gasket from the front exhaust pipe assembly.



4. REMOVE FRONT EXHAUST PIPE ASSEMBLY


    A254707
  1. Remove the 2 bolts, 2 compression springs.

  1. Remove the front exhaust pipe assembly from the exhaust pipe support.

  1. Remove the gasket from the exhaust manifold converter sub-assembly.