Home › Brake › BRAKE (FRONT) › FRONT BRAKE

FRONT BRAKE > DISASSEMBLY

for Preparation Click here



1. REMOVE CYLINDER BOOT


    C239579E01
  1. Using a screwdriver with its tip wrapped with vinyl tape, remove the front disc brake piston set ring and cylinder boot from the disc brake cylinder assembly.
    Text in Illustration 
    *1
    Vinyl Tape

    NOTICE:
    Be careful not to damage the front disc brake piston or front disc brake cylinder.



2. REMOVE FRONT DISC BRAKE PISTON
  1. Place a piece of cloth between the front disc brake piston and front disc brake cylinder.



    C238491
  1. Apply compressed air to remove the front disc brake piston from the front disc brake cylinder.

    CAUTION:
    Do not place your fingers in front of the front disc brake piston when using compressed air.

    NOTICE:
    Do not allow any brake fluid to spatter.



3. REMOVE PISTON SEAL


    C132807E02
  1. Using a screwdriver with its tip wrapped with vinyl tape, remove the piston seal from the front disc brake cylinder.
    Text in Illustration 
    *1
    Vinyl Tape

    NOTICE:
    Do not damage the inner surface or piston seal groove of the front disc brake cylinder.



4. REMOVE FRONT DISC BRAKE BLEEDER PLUG CAP


5. REMOVE FRONT DISC BRAKE BLEEDER PLUG