FRONT BRAKE > REASSEMBLY |
| 1. TEMPORARILY TIGHTEN FRONT DISC BRAKE BLEEDER PLUG |
| 2. INSTALL FRONT DISC BRAKE BLEEDER PLUG CAP |
| 3. INSTALL PISTON SEAL |
![]() |
Apply a light layer of lithium soap base glycol grease to the entire circumference of a new piston seal.
![]() | Lithium Soap Base Glycol Grease |
Install the piston seal to the front disc brake cylinder.
| 4. INSTALL FRONT DISC BRAKE PISTON |
![]() |
Apply a light layer of lithium soap base glycol grease to the entire circumference of a new cylinder boot.
| *1 | Cylinder Boot |
| *2 | Front Disc Brake Piston |
![]() | Lithium Soap Base Glycol Grease |
Install the cylinder boot to the front disc brake piston.
Apply a light layer of lithium soap base glycol grease to the contact surfaces of the front disc brake piston, and install it to the front disc brake cylinder.
| 5. INSTALL CYLINDER BOOT |
![]() |
Install the cylinder boot to the front disc brake cylinder.
| *1 | Front Disc Brake Piston Set Ring |
| *2 | Cylinder Boot |
![]() |
Using a screwdriver, install a new front disc brake piston set ring.
| *1 | Vinyl Tape |