Home › Vehicle Exterior › LIGHTING (EXT) › MANUAL HEADLIGHT BEAM LEVEL CONTROL SYSTEM

MANUAL HEADLIGHT BEAM LEVEL CONTROL SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use the following procedure to troubleshoot the manual headlight beam level control system.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS CHECK AND SYMPTOM CHECK

      NEXT


      3.INSPECT BATTERY VOLTAGE
      1. Measure the battery voltage with the ignition switch off.

      2. Standard Voltage:
        11 to 14 V

        If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

      NEXT


      4.PROBLEM SYMPTOMS TABLE
      1. Refer to Problem Symptoms Table (Click here).


      NEXT


      5.ADJUST, REPAIR OR REPLACE

        NEXT


        6.CONFIRMATION TEST

          NEXT

          END