Component
| Outline
|
Rear Height Control Sensor Sub-assembly
| Detects vehicle height.
|
Combination Meter Assembly
| - Outputs the vehicle speed signal to the headlight leveling ECU assembly.
- The headlight beam level control system indicator light in the combination meter illuminates for 3 seconds and then goes off when the ignition switch is turned to ON (bulb check function).
- The headlight beam level control system indicator light in the combination meter illuminates to alert the driver when a malfunction in this system is detected.
|
Headlight Leveling Motor
| Based on the signals received from the headlight leveling ECU assembly, each motor moves the reflector in the headlight to vary its low beam.
|
Headlight Leveling ECU Assembly
| - Based on the signals that are transmitted by the rear height control sensor sub-assembly and combination meter assembly, the headlight leveling ECU assembly detects the amount of variance of the vehicle posture while the vehicle is stopping.
- Based on the detected value, the headlight leveling ECU assembly outputs control signals to the headlight leveling motor.
- The headlight leveling ECU assembly turns on the headlight beam level control system indicator light for 3 seconds when the ignition switch is turned to ON (bulb check function).
- The headlight leveling ECU assembly turns on the headlight beam level control system indicator light to alert the driver when a malfunction in this system is detected.
|