Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM

AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



DATA LIST

HINT:
Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the intelligent tester on.

  4. Enter the following menus: Body / HL Auto Leveling / Data List.

  5. Read the Data List according to the display on the intelligent tester.

    HL Auto Leveling 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Headlight Low Beam State
    Low beam headlight state/ON or OFF
    ON: Low beam headlights on
    OFF: Low beam headlights off
    -
    +B
    IG power supply voltage value/0.00 to 19.75 V
    11 to 14 V
    -
    Height Sens Pw Supply Val
    Height control sensor power supply value/0.00 to 5.00 V
    Approx. 5 V
    -
    Rr Height Sens Signal Val
    Rear height control sensor signal value/0.00 to 5.00 V
    Approx. 2.5 V (When vehicle is level)
    Value changes according to vehicle height
    Vehicle Speed
    Vehicle speed/0.00 to 327.67 km/h (203.61 mph)
    Condition can be displayed
    -
    Rear Height Adjust Valid Flag
    Rear height adjustment range/VALID or INVALID
    Condition can be displayed
    -
    Init Writing Count
    Number of times for initialization/0 to 255
    Condition can be displayed
    -
    Sensor Initialization Hist
    Sensor Initialization History/not comp, 10%, 25%, 50%, 75%, 100% or complied
    Condition can be displayed
    -
    Number Of Trouble Codes
    Number of trouble codes/0 to 255
    Condition can be displayed
    -


ACTIVE TEST

HINT:
Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the intelligent tester on.

  4. Enter the following menus: Body / HL Auto Leveling / Active Test.

  5. Perform the Active Test according to the display on the intelligent tester.

    HL Auto Leveling 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Drive The Leveling Motor UP*1
    Leveling motor upward operation
    ON/OFF
    ON: Moves up
    OFF: Stops
    Drive The Leveling Motor DOWN*1
    Leveling motor downward operation
    ON/OFF
    ON: Moves down
    OFF: Stops
    *1: Perform the active test with the engine running.