DTC B2784 Antenna Coil Open / Short |
| DTC Code | DTC Detection Condition | Trouble Area | DTC Output Confirmation Operation |
| B2784 | The transponder key amplifier coil built into the engine switch is open (see below) or shorted (determined by communication with certification ECU (smart key ECU assembly)) (1 trip detection logic*).
|
| With the shift lever in P, the key is held near the engine switch and an engine start operation is performed by pressing and holding the engine switch when the key battery is depleted. |
| Vehicle Condition when Malfunction Detected | Fail-safe Operation when Malfunction Detected |
| Engine cannot be started when key battery is depleted by holding key near engine switch and pressing and holding engine switch with shift lever in P | - |
| DTC Code | Data List and Active Test |
| B2784 | - |

| 1.CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) - ENGINE SWITCH) |
Disconnect the I78 certification ECU (smart key ECU assembly) connector.
Disconnect the I58 engine switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I78-7 (CODE) - I58-8 (CODE) | Always | Below 1 Ω |
| I78-9 (TXCT) - I58-7 (TXCT) | Always | Below 1 Ω |
| I78-1 (VC5) - I58-10 (VC5) | Always | Below 1 Ω |
| I78-24 (AGND) - I58-6 (AGND) | Always | Below 1 Ω |
| I58-8 (CODE) - Body ground | Always | 10 kΩ or higher |
| I58-7 (TXCT) - Body ground | Always | 10 kΩ or higher |
| I58-10 (VC5) - Body ground | Always | 10 kΩ or higher |
| I58-6 (AGND) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 2.REPLACE ENGINE SWITCH |
Temporarily replace the engine switch with a new or known good one (Click here for 2GR-FE, Click here for 2AR-FE).
| NEXT | |
| 3.CLEAR DTC |
Clear the DTCs (Click here).
| NEXT | |
| 4.CHECK DTC OUTPUT |
Check for DTCs (Click here).
|
| ||||
| OK | ||
| ||