DTC P0560 System Voltage |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0560 | Open in TCM back-up power source circuit. DTC is detected for 3 sec. or more (1 trip detection logic). |
|

| 1.CHECK DTC OUTPUT |
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Powertrain / Engine / DTC.
Read the DTCs using the intelligent tester.
| Display (DTC Output) | Proceed to |
| No DTC | A |
| P0560 is output (engine control system) | B |
|
| ||||
| A | |
| 2.INSPECT TCM (POWER SOURCE, GROUND) |
Disconnect the TCM connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E7-1 (BATT) - E7-8 (E1) | Always | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E7-8 (E1) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||