AUTOMATIC TRANSAXLE SYSTEM > REGISTRATION |
| 1. INPUT TRANSAXLE COMPENSATION CODE INTO TCM (Procedure 1) |
![]() |
Record the transaxle compensation code specified on the QR label.
Move the shift lever to N or P.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Powertrain / ECT / Utility / A/T Code Registration.
Select "Set Compensation Code".
Register the compensation code.
Press "Input".
Manually input the transaxle compensation code. The code is a 60-digit alphanumeric value printed on the QR label. After inputting the code, press "OK".
Check that the compensation code displayed on the screen is correct by comparing it with the 60-digit alphanumeric value on the QR label.
Press "NEXT" to set the compensation code to the TCM.
Press "EXIT".
| 2. TRANSFER TRANSAXLE COMPENSATION CODE (Procedure 2) |
Move the shift lever to N or P.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Read the transaxle compensation code.
Enter the following menus: Powertrain / ECT / Utility / A/T Code Registration.
Select "Read Compensation Code".
Press "Save".
Press "Save" or "Overwrite".
Press "EXIT".
Turn the engine switch off.
Replace the TCM.
Set the transaxle compensation code.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Powertrain / ECT / Utility / A/T Code Registration.
Select "Set Compensation Code".
Press "Open".
Press "Open" again to proceed.
Press "Exit".