Home › Engine / Hybrid System · 2GR-FE › FUEL › FUEL PUMP

FUEL PUMP > DISASSEMBLY

for Preparation Click here



1. REMOVE FUEL SENDER GAUGE ASSEMBLY


    A136021
  1. Disconnect the fuel sender gauge connector.



    A143717
  1. Release the lock as shown in the illustration and slide the fuel sender gauge assembly to remove it.



2. REMOVE LOWER FUEL TANK CASE SUB-ASSEMBLY


    A136231
  1. Disconnect the fuel pump harness connectors from the fuel suction plate.



    A136234E03
  1. Using needle nose pliers, remove the E-ring.
    Text in Illustration 
    *1
    E-ring



    A218240E03
  1. Disengage the 4 claws of the No. 1 fuel suction support and remove the lower fuel tank case sub-assembly from the fuel suction plate with the fuel filter.
    Text in Illustration 
    *1
    Tube

  1. Remove the spring from the fuel suction plate.

    NOTICE:
    Do not do anything which may separate the fuel tube from either the fuel suction plate or fuel filter assembly, such as applying excessive force to the tube (Click here).



3. REMOVE NO. 1 FUEL SUCTION SUPPORT


    A259328
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the No. 1 fuel suction support.



4. REMOVE FUEL PUMP


    A222006E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 5 claws, and remove the fuel pump from the fuel filter.
    Text in Illustration 
    *1
    Fuel Filter
    *2
    Suction Filter

    NOTICE:
    1. Do not damage the fuel filter.
    2. Do not remove the suction filter.
    3. Do not use either the fuel pump or the suction filter if the suction filter is removed from the fuel pump.



    A259330
  1. Remove the fuel pump harness connector.



    A204270E03
  1. Remove the fuel pump filter seal from the fuel pump. If the fuel pump filter seal still remains in the fuel filter element, remove it using a wire tip (φ1 mm) that is formed as shown in the illustration.
    Text in Illustration 
    *1
    Fuel Pump Filter Seal
    *a
    5.0 mm (0.197 in.)

    NOTICE:
    Be careful not to damage the sealing surface.



    A171480
  1. Remove the fuel pump spacer from the fuel pump.