Home › Engine / Hybrid System ยท 1AZ-FE › FUEL › FUEL PUMP

FUEL PUMP > REASSEMBLY

for Preparation Click here



1. INSTALL FUEL PUMP


    A288172E01
  1. Apply a light coat of fuel to a new O-ring. Then install the O-ring and fuel pump spacer to the fuel pump.
    Text in Illustration 
    *1
    O-ring
    *2
    Fuel Pump Spacer



    A136240E01
  1. Engage the 5 claws on the fuel filter and install the fuel pump with the suction filter.
    Text in Illustration 
    *1
    Fuel Filter
    *2
    Suction Filter

    NOTICE:
    1. Make sure that the O-ring is not cut or pinched during installation.
    2. Engage the claws securely.
    3. Do not remove the suction filter.



2. INSTALL NO. 1 FUEL SUCTION SUPPORT


    A255955
  1. Engage the 2 claws of the No. 1 fuel suction support.

  1. Connect the fuel pump harness connector to the fuel pump.



3. INSTALL LOWER FUEL TANK CASE SUB-ASSEMBLY
  1. Install the spring to the fuel suction plate sub-assembly.



    A211201
  1. Engage the 4 claws of the No. 1 fuel suction support to install the lower fuel tank case sub-assembly to the fuel suction plate sub-assembly with the fuel filter.

  1. Install a new E-ring.

  1. Connect the fuel pump harness connectors to the fuel suction plate sub-assembly.



4. INSTALL FUEL SENDER GAUGE ASSEMBLY


    A136241
  1. Slide the fuel sender gauge assembly to fit the claw.

  1. Connect the connector of the fuel sender gauge assembly.