Home › Engine / Hybrid System ยท 1AZ-FE › ENGINE MECHANICAL › DRIVE BELT

DRIVE BELT > INSTALLATION

for Preparation Click here



1. INSTALL V-RIBBED BELT


    A127534E01
  1. Set the V-ribbed belt onto each part as shown in the illustration.
    Text in Illustration 
    *1
    V-ribbed Belt Tensioner Assembly
    *2
    Generator
    *3
    Water Pump
    *4
    Cooler Compressor
    *5
    Crankshaft
    *6
    Idler

  1. Using SST, slowly turn the V-ribbed belt tensioner assembly clockwise and install the V-ribbed belt.

    SST
    09216-42010  

    NOTICE:
    1. Make sure that SST and other tools are set to the V-ribbed belt tensioner assembly securely.
    2. When compressing the V-ribbed belt tensioner assembly, slowly turn the V-ribbed belt tensioner assembly.



2. INSTALL FRONT FENDER APRON SEAL RH


3. INSTALL ENGINE UNDER COVER RH


4. INSTALL FRONT WHEEL OPENING EXTENSION PAD RH


5. INSTALL FRONT WHEEL RH

Torque:
103 N*m{ 1050 kgf*cm , 76 ft.*lbf }