Home › Vehicle Exterior › WIPER / WASHER › FRONT WIPER MOTOR

FRONT WIPER MOTOR > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT WINDSHIELD WIPER MOTOR ASSEMBLY (for LHD)


  1. for RH Side:



      E226089E01
    1. Check the stop (park) position.

    2. Operate the windshield wiper motor assembly.

    3. Stop the windshield wiper motor assembly operation.

    4. Check the automatic stop (park) position.

      HINT:
      After the front wiper motor is stopped, check the automatic stop position after lifting the wiper blade 2 times.

      OK:
      The front wiper stops at the position shown in the illustration.
      Area
      Measurement
      A
      7.5mm (0.295 in.)

      Text in Illustration 
      *1
      Ceramic Dot



  1. for LH Side:



      E226090E01
    1. Operate the windshield wiper motor assembly.

    2. Stop the windshield wiper motor assembly operation.

    3. Check the automatic stop (park) position.

      HINT:
      After the front wiper motor is stopped, check the automatic stop position after lifting the wiper blade 2 times.

      OK:
      The front wiper stops at the position shown in the illustration.
      Area
      Measurement
      A
      7.5mm (0.295 in.)

      Text in Illustration 
      *1
      Ceramic Dot



2. INSPECT WINDSHIELD WIPER MOTOR ASSEMBLY (for RHD)


  1. for LH Side:



      E230006E01
    1. Check the stop (park) position.

    2. Operate the windshield wiper motor assembly.

    3. Stop the windshield wiper motor assembly operation.

    4. Check the automatic stop (park) position.

      HINT:
      After the front wiper motor is stopped, check the automatic stop position after lifting the wiper blade 2 times.

      OK:
      The front wiper stops at the position shown in the illustration.
      Area
      Measurement
      A
      7.5mm (0.295 in.)

      Text in Illustration 
      *1
      Ceramic Dot



  1. for RH Side:



      E230007E01
    1. Check the stop (park) position.

    2. Operate the windshield wiper motor assembly.

    3. Stop the windshield wiper motor assembly operation.

    4. Check the automatic stop (park) position.

      HINT:
      After the front wiper motor is stopped, check the automatic stop position after lifting the wiper blade 2 times.

      OK:
      The front wiper stops at the position shown in the illustration.
      Area
      Measurement
      A
      7.5mm (0.295 in.)

      Text in Illustration 
      *1
      Ceramic Dot