Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › STEERING PAD

STEERING PAD > INSTALLATION

for Preparation Click here



1. INSTALL HORN BUTTON ASSEMBLY
  1. Check that the ignition switch is off.

  1. Check that the cable is disconnected from the negative (-) battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



    B282205E01
  1. Connect the airbag connector to the horn button assembly.
    Text in Illustration 
    *1
    Airbag Connector
    *2
    Horn Connector
    *3
    Airbag Connector Lock

    NOTICE:
    When connecting any airbag connector, take care not to damage the airbag wire harness.

  1. Push in the lock to install the airbag connector.

  1. Connect the horn connector to the horn button assembly.



    B279728
  1. Push the horn button assembly to engage the 3 pins carefully.

    NOTICE:
    1. Make sure that the pins are securely inserted into the steering holes.
    2. Make sure to engage the 2 upper pins first.
    3. Make sure that the horn button assembly is securely installed.



2. INSTALL LOWER NO. 3 STEERING WHEEL COVER
  1. Engage the claw and guide to install the lower No. 3 steering wheel cover.



3. INSTALL LOWER NO. 2 STEERING WHEEL COVER
  1. Engage the claw and guide to install the lower No. 2 steering wheel cover.



4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



5. INSPECT HORN BUTTON ASSEMBLY
  1. Make sure that the horn sounds.

    HINT:
    If the horn does not sound, inspect the horn system (Click here).



6. PERFORM DIAGNOSTIC SYSTEM CHECK
for Separate Type Yaw Rate Sensor: (Click here)
for Built-in Type Yaw Rate Sensor: (Click here)


7. INSPECT SRS WARNING LIGHT
for Separate Type Yaw Rate Sensor: (Click here)
for Built-in Type Yaw Rate Sensor: (Click here)