Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › CURTAIN SHIELD AIRBAG ASSEMBLY

CURTAIN SHIELD AIRBAG ASSEMBLY > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The procedure listed below is for the LH side.



1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY
  1. Check that the ignition switch is off.

  1. Check that the cable is disconnected from the negative (-) battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



  1. Temporarily install the curtain shield airbag assembly with the 2 hooks.


    B278811E01

    NOTICE:
    1. When installing the curtain shield airbag assembly, have assistants hold it to prevent it from bending.
    2. Do not twist the curtain shield airbag assembly when installing it.

  1. Install 2 new bolts in the order shown in the illustration.

    Torque:
    11 N*m{ 110 kgf*cm , 8 ft.*lbf }



  1. Install the curtain shield airbag assembly to the body panel with 5 claws, 6 new clips and 2 new spacers in the order shown in the illustration.


    B278809E01


    Text in Illustration 
    *1
    Pin
    *2
    Clip
    *3
    Curtain Shield Airbag Assembly
    *4
    Body Panel
    *5
    Spacer
    -
    -



    B278807
  1. Push in a new pin to each clip.

    NOTICE:
    Make sure that the pins of the clips are pushed in firmly.



    B278805E01
  1. Connect the curtain shield airbag connector.
    Text in Illustration 
    *1
    Airbag Connector
    *2
    Airbag Connector Lock

    NOTICE:
    When connecting any airbag connector, take care not to damage the airbag wire harness.

  1. Push in the lock to install the curtain shield airbag connector.



2. INSTALL ROOF HEADLINING ASSEMBLY
(Click here)


3. PERFORM DIAGNOSTIC SYSTEM CHECK
for Separate Type Yaw Rate Sensor: (Click here)
for Built-in Type Yaw Rate Sensor: (Click here)