METER / GAUGE SYSTEM > Tachometer Malfunction |

| 1.CHECK CAN COMMUNICATION SYSTEM |
Check if a CAN communication DTC is output (Click here).
| Result | Proceed to |
| CAN communication DTC is not output. | A |
| CAN communication DTC is output. | B |
|
| ||||
| A | |
| 2.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (TACHO METER OPERATION) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / Combination Meter / Active Test.
Check the operation by referring to the table below.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Tacho Meter Operation | Tachometer | 0, 1000, 2000, 3000, 4000, 5000, 6000, 7000 (rpm) | - |
|
| ||||
| OK | |
| 3.CHECK SFI SYSTEM |
Check if the SFI system output the DTC (Click here for 2AR-FE, Click here for 2GR-FE).
| Result | Proceed to |
| The DTC is not output. | A |
| The DTC is output (for 2AR-FE). | B |
| The DTC is output (for 2GR-FE). | C |
|
| ||||
|
| ||||
| A | |
| 4.READ VALUE USING INTELLIGENT TESTER (ENGINE SPEED, ENGINE RPM) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus:
for Engine and ECT: Powertrain / Engine and ECT / Data List.
for Combination Meter: Body / Combination Meter / Data List.
Check the values by referring to the table below.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Engine Speed | Engine speed/Min.: 0 rpm, Max.: 16383 rpm |
|
|
Results of real-vehicle check:
| |||
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Engine Rpm | Engine speed/Min.: 0 rpm, Max.: 12750 rpm |
| - |
| Result | Proceed to |
| The data list values of the ECUs match. | A |
| The data list values of the ECUs do not match (for 2AR-FE). | B |
| The data list values of the ECUs do not match (for 2GR-FE). | C |
|
| ||||
|
| ||||
| A | ||
| ||