Home › Engine / Hybrid System ยท 2GR-FE › ENGINE CONTROL › CRANKSHAFT POSITION SENSOR

CRANKSHAFT POSITION SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL CRANK POSITION SENSOR


    A191152E02
  1. Apply a light coat of engine oil to the O-ring on the crank position sensor.
    Text in Illustration 
    *1
    O-ring

  1. Install the crank position sensor with the bolt.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

  1. Connect the crank position sensor connector.



2. INSTALL COMPRESSOR AND MAGNETIC CLUTCH
  1. Install the compressor and magnetic clutch (Click here).