FUEL INJECTOR > INSPECTION |
| 1. INSPECT FUEL INJECTOR ASSEMBLY |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | 20°C (68°F) | 11.6 to 12.4 Ω |
Inspect the injector injection.
![]() |
Connect SST (fuel tube connector) to SST (hose) with SST (clip), and then connect them to the fuel pipe (vehicle side).
| *1 | SST (Hose) |
| *2 | SST (Hose Band) |
| *3 | SST (Fuel Tube Connector) |
| *4 | Fuel Pipe (Vehicle Side) |
![]() |
Install a new O-ring to the fuel injector.
| *1 | SST (Hose) |
| *2 | SST (Hose Band) |
| *3 | SST (Adapter) |
| *4 | O-ring |
| *5 | SST (Clamp) |
| *6 | Vinyl Tube |
Connect SST (adapter and hose) to the injector, and hold the injector and union with SST (clamp).
Install a vinyl tube onto the injector.
![]() |
Tie the clamp and adapter together with a tie band as shown in the illustration.
| *1 | SST (Tie Band) |
| *2 | SST (Adapter) |
| *3 | SST (Clamp) |
Put the injector into the graduated cylinder.
Operate the fuel pump.
![]() |
Connect SST (wire) to the injector and the battery for 15 seconds, and measure the injection volume with the graduated cylinder. Test each injector 2 or 3 times.
| *1 | SST (Wire) |
| *a | Connect |
| Tester Connection | Condition | Specified Condition |
| Positive terminal - Ground terminal | Per 15 seconds | 87 to 105 cc (5.3 to 6.4 cu.in.) |
Check for fuel drop.
In the condition above, disconnect the tester probes of SST (wire) from the battery and check for fuel drop from the injector.