AUTOMATIC TRANSAXLE SYSTEM > DTC CHECK / CLEAR |
| CHECK DTC |
DTCs which are stored in the ECM can be displayed with Intelligent tester.
These scan tools can display pending DTCs and current DTCs. Some DTC are not stored if the ECM does not detect a malfunction during consecutive driving. However, the detected malfunction during once driving is stored as pending DTC.
Connect Intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the Intelligent tester switch on.
Enter the following menus: Enter / Powertrain / Engine and ECT / DTC / Current (or Pending).
Confirm the DTCs and freeze frame data and then write them down.
Confirm the details of the DTCs (Click here).
| CLEAR DTC WITH INTELLIGENT TESTER |
Connect Intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the Intelligent tester switch on.
Enter the following menus: Enter / Powertrain / Engine and ECT / DTC / Clear.