AUTOMATIC TRANSAXLE SYSTEM > HYDRAULIC TEST |
| PERFORM HYDRAULIC TEST |
![]() |
Measure the line pressure.
Warm up the Automatic Transmission Fluid (ATF).
Lift the vehicle up.
Remove the engine under cover.
Remove the test plug on the transaxle case front left side and install the SST.
Lower the vehicle.
Fully apply the parking brake and chock the 4 wheels.
Connect the intelligent tester to the DLC3.
Start the engine.
Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the Shift Position.
Move the shift lever to D, and then use the intelligent tester to hold 3rd gear using Active Test. Measure the line pressure while the engine is idling.
| Condition | D Position kPa (kgf/cm2, psi) |
| Idling | 360 to 430 kPa (3.7 to 4.4 kgf/cm2, 52 to 62 psi) |
Turn the ignition switch off.
![]() |
Disconnect the harness connector from the wiring harness connector.
Start the engine.
Firmly depress the brake pedal, move the shift lever to D, depress the accelerator pedal all the way down, and check the line pressure while the stall test is performed.
| Condition | D Position kPa (kgf/cm2, psi) |
| Stall test | 1160 to 1350 kPa (11.8 to 13.8 kgf/cm2, 168 to 196 psi) |
Turn the ignition switch off.
Connect the harness connector, depress the brake pedal firmly, move the shift lever to R, and check that the line pressure while the engine is idling and during the stall test.
| Condition | R Position kPa (kgf/cm2, psi) |
| Idling | 670 to 820 kPa (6.8 to 8.4 kgf/cm2, 97 to 119 psi) |
| Stall test | 1650 to 1910 kPa (16.8 to 19.5 kgf/cm2, 239 to 277 psi) |
Remove the SST, install the test plug.
Clear the DTCs (Click here).
| Test Result | Possible Cause |
| Measured values are higher than the specified value in all positions |
|
| Measured values are lower than the specified value in all positions |
|
| Pressure is low in D only |
|
| Pressure is low in R only |
|