Home › Drivetrain ยท U241E AUTOMATIC TRANSMISSION / TRANSAXLE › AUTOMATIC TRANSAXLE SYSTEM

AUTOMATIC TRANSAXLE SYSTEM > HYDRAULIC TEST

for Preparation Click here



PERFORM HYDRAULIC TEST


    D025472E02
  1. Measure the line pressure.

    NOTICE:
    1. Perform the test at the normal operating ATF (Automatic Transmission Fluid) temperature: 50 to 80°C (122 to 176°F).
    2. The line pressure test should always be carried out in pairs. One technician should observe the conditions of wheels or wheel stoppers outside the vehicle while the other is performing the test.
    3. Be careful to prevent SST hose from interfering with the exhaust pipe.
    4. This Check must be conducted after checking and adjusting engine.
    5. Perform under condition that A/C is OFF.
    6. When conducting stall test, do not continue more than 5 seconds.


    1. Warm up the ATF.

    2. Remove the test plug on the front side of the transaxle case and connect SST.

      SST
      09992-00095   (09992-00231, 09992-00271)

    3. Fully apply the parking brake and chock the 4 wheels.

    4. Connect the Intelligent tester to the DLC3.

    5. Start the engine and check idling speed.

    6. Keep your left foot pressing firmly on the brake pedal and shift into D position.

    7. Measure the line pressure when the engine is idling.

    8. Depress the accelerator pedal all the way down. Quickly read the highest line pressure when engine speed reaches stall speed.

    9. In the same way, do the test in R position.

      Specified line pressure: 
      Condition
      D position kPa (kgf/cm2, psi)
      R position kPa (kgf/cm2, psi)
      Idling
      372 to 412 kPa
      (3.8 to 4.2 kgf/cm2, 54 to 60 psi)
      672 to 742 kPa
      (6.9 to 7.6 kgf/cm2, 97 to 108 psi)
      Stall test
      930 to 1040 kPa
      (9.5 to 10.6 kgf/cm2, 135 to 151 psi)
      1760 to 1970 kPa
      (17.9 to 20.1 kgf/cm2, 255 to 286 psi)

      Evaluation: 
      Problem
      Possible cause
      If the measured values at all positions are higher
      1. Line pressure control solenoid (SLT) defective
      2. Regulator valve defective
      If the measured values at all positions are lower
      1. Line pressure control solenoid (SLT) defective
      2. Regulator valve defective
      3. Oil pump defective
      4. U/D (Underdrive) direct clutch defective
      If pressure is low in the D position only
      1. D position circuit fluid leak
      2. Forward clutch defective
      If pressure is low in the R position only
      1. R position circuit fluid leak
      2. Direct clutch defective
      3. 1st and reverse brake defective