AUTOMATIC TRANSAXLE SYSTEM > INITIALIZATION |
| RESET TRANSAXLE COMPENSATION CODE |
Move the shift lever to N or P.
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Powertrain / Engine and ECT / Utility / A/T Code Reset.
Press "Next" again to proceed.
Press "Exit".
| PERFORM ROAD TEST TO ALLOW ECM TO LEARN |
Warm up the engine.
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Powertrain / Engine and ECT / Data List / Throttle Sensor Position.
From a standstill, achieve highest possible speed with the accelerator pedal opened 15% or less. Keep the accelerator pedal angle steady while driving the vehicle.
Repeat the previous step until shift shock no longer occurs.
From a standstill, achieve highest possible speed with the accelerator pedal opened 25% to 35%. Keep the accelerator pedal angle steady while driving the vehicle.
Repeat the previous step until shift shock no longer occurs.
| RESET MEMORY |
Reset procedure is as follows.
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: "Powertrain / Engine and ECT / Utility / Reset Memory". Then, press "Next".