AUTOMATIC TRANSAXLE SYSTEM > INITIALIZATION |
| RESET TRANSAXLE COMPENSATION CODE |
Move the shift lever to N or P.
Turn the engine switch off.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Powertrain / ECT / Utility / A/T Code Reset.
Press "Next" again to proceed.
Press "Exit".
| PERFORM ROAD TEST TO ALLOW TCM TO LEARN |
Warm up the engine.
Turn the engine switch off.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Powertrain / ECT / Data List / Throttle Position from EFI.
From a standstill, achieve highest possible speed with the accelerator pedal opened 15% or less. Keep the accelerator pedal angle steady while driving the vehicle.
Repeat the previous step until shift shock no longer occurs.
From a standstill, achieve highest possible speed with the accelerator pedal opened 25% to 35%. Keep the accelerator pedal angle steady while driving the vehicle.
Repeat the previous step until shift shock no longer occurs.
| RESET MEMORY |
Reset procedure is as follows.
Turn the engine switch off.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: "Powertrain / ECT / Utility / Reset Memory". Then, press "Next".