Home › Drivetrain ยท U241E AUTOMATIC TRANSMISSION / TRANSAXLE › AUTOMATIC TRANSAXLE SYSTEM

AUTOMATIC TRANSAXLE SYSTEM > INITIALIZATION

for Preparation Click here



RESET MEMORY

NOTICE:
  1. Perform RESET MEMORY (AT initialization) when replacing the automatic transaxle assembly, engine assembly or ECM.
  2. RESET MEMORY can be performed only with the Intelligent tester.

HINT:
The ECM learns various conditions and controls the automatic transaxle assembly and engine assembly according to those characteristics. Therefore, when the automatic transaxle assembly, engine assembly, or ECM has been replaced, it is necessary to reset the memory so that the ECM can re-learn.
Reset procedure is as follows.

  1. Turn the ignition switch off.

  2. Connect the Intelligent tester to the DLC3.

  3. Turn the ignition switch to ON and Intelligent tester on.

  4. Enter the following menu: Powertrain / Engine and ECT / Utility / Reset Memory. Then, press "Next".

    CAUTION:
    After performing RESET MEMORY, be sure to perform the ROAD TEST (Click here) described earlier.

    HINT:
    The ECM learns when the ROAD TEST is performed.