Home › Vehicle Interior › SEAT › LUMBAR SWITCH

LUMBAR SWITCH > INSPECTION

for Preparation Click here



1. INSPECT LUMBAR FRONT POWER SEAT SWITCH


B239575E08
  1. Measure the resistance according to the value(s) in the table below.
    Text in Illustration 
    *1
    1. Hold Switch (for LHD)
    2. Release Switch (for RHD)
    *2
    1. Release Switch (for LHD)
    2. Hold Switch (for RHD)
    *a
    Component without harness connected
    (Lumbar Front Power Seat Switch)

    Standard Resistance:
    for LHD 
    Tester Connection
    Switch Condition
    Specified Condition
    3 - 5
    Hold
    Below 1 Ω
    1 - 2
    3 - 2
    Off
    1 - 2
    3 - 2
    Release
    1 - 5
    for RHD 
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 5
    Hold
    Below 1 Ω
    3 - 2
    1 - 2
    Off
    3 - 2
    1 - 2
    Release
    3 - 5

    If the result is not as specified, replace the lumbar front power seat switch.