DTC P0724 Brake Switch "B" Circuit High |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0724 | The stop light switch remains ON even when the vehicle is driven in a STOP (less than 3 km/h (1.86 mph)) and GO (30 km/h (18.65 mph) or more) fashion 5 times. (2-trip detection logic). |
|

| 1.READ VALUE USING DATA LIST (STP SIGNAL) |
Turn the engine switch off.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Powertrain / ECT / Data List.
According to the display on the intelligent tester, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Stop Light Switch | Stop light switch status/ ON or OFF | Brake pedal is
| - |
|
| ||||
| OK | ||
| ||
| 2.CHECK STOP LIGHT SWITCH ASSEMBLY INSTALLATION |
Check the stop light switch assembly installation (Click here).
|
| ||||
| OK | |
| 3.INSPECT STOP LIGHT SWITCH ASSEMBLY |
Inspect the stop light switch assembly (Click here).
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (STOP LIGHT SWITCH ASSEMBLY - TCM) |
![]() |
Install the stop light switch assembly.
Connect the stop light switch connector.
Disconnect the TCM connector.
Measure the voltage according to the value(s) in the table below when the brake pedal is depressed and released.
| Tester Connection | Condition | Specified Condition |
| E7-12 (STP) - Body ground | Brake pedal is depressed | 7.5 to 14 V |
| E7-12 (STP) - Body ground | Brake pedal is released | Below 1 V |
| *a | Front view of wire harness connector (to TCM) |
|
| ||||
| OK | ||
| ||