REAR SEAT OUTER BELT ASSEMBLY > ON-VEHICLE INSPECTION |
| 1. INSPECT REAR SEAT OUTER BELT ASSEMBLY (for Vehicle not Involved in Collision) |
Perform a diagnostic system check (Click here). (for Built-in Type Yaw Rate Sensor)
Perform a diagnostic system check (Click here). (for Separate Type Yaw Rate Sensor)
Visually check for defects with the rear seat outer belt assembly installed on the vehicle.
The defects are as follows:
| 2. INSPECT REAR SEAT OUTER BELT ASSEMBLY (for Vehicle Involved in Collision) |
Perform a diagnostic system check (Click here). (for Built-in Type Yaw Rate Sensor)
Perform a diagnostic system check (Click here). (for Separate Type Yaw Rate Sensor)
Visually check for defects with the rear seat outer belt assembly removed from the vehicle.
The defects are as follows: