AFS (ADAPTIVE FRONT-LIGHTING SYSTEM) > AFS OFF Switch Circuit |

| 1.READ VALUE USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / AFS / Data List.
Read the display on the intelligent tester.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| AFS OFF Switch | Headlight swivel main switch signal/ ON or OFF | ON: Headlight swivel main switch pushed OFF: Headlight swivel main switch not pushed | - |
|
| ||||
| OK | ||
| ||
| 2.INSPECT HEADLIGHT SWIVEL MAIN SWITCH |
Remove the headlight swivel main switch (Click here).
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 6 - 3 | Not pushed (OFF) | 10 kΩ or higher |
| Pushed (ON) | Below 1 Ω |
| *a | Component without harness connected (Headlight Swivel Main Switch) |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (HEADLIGHT SWIVEL MAIN SWITCH - AFS ECU) |
Disconnect the A35 AFS ECU (headlight swivel ECU assembly) connector.
Disconnect the I8 headlight swivel main switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A35-32 (MSW) - I8-6 | Always | Below 1 Ω |
| A35-32 (MSW) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (HEADLIGHT SWIVEL MAIN SWITCH - BODY GROUND) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I8-3 - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||