DTC B2271 Ignition Hold Monitor Malfunction |
| DTC Code | DTC Detection Condition | Trouble Area | DTC Output Confirmation Operation |
| B2271 | When either of the following conditions is met (1-trip detection logic*):
|
| Turn the engine switch on (IG).
|
| Vehicle Condition when Malfunction Detected | Fail-safe Function when Malfunction Detected |
| The engine switch cannot be turned on (IG) (the engine cannot be started). | The power source mode cannot be changed to on (IG). |

| DTC | Data List Item | Active Test Item |
| B2271 | Power Source Control
Starting Control
| - |
| 1.CHECK HARNESS AND CONNECTOR (POWER SOURCE) |
![]() |
Disconnect the A43 connector from the certification ECU (smart key ECU assembly).
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A43-2 (+B) - Body ground | Always | 11 to 14 V |
| *a | Rear view of wire harness connector (to Certification ECU (smart key ECU assembly)) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (GROUND) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A43-11 (E) - Body ground | Always | Below 1 Ω |
| *a | Rear view of wire harness connector (to Certification ECU (smart key ECU assembly)) |
|
| ||||
| OK | |
| 3.CHECK CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) |
Reconnect the certification ECU (smart key ECU assembly) connector.

| *a | Component with harness connected (Certification ECU (Smart Key ECU Assembly)) | - | - |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A43-9 (IG2D) - Body ground | Engine switch on (ACC) → Engine switch on (IG) | 1 V or less → 9 V or higher |
| I78-6 (IG1D) - Body ground | Engine switch on (ACC) → Engine switch on (IG) | 1 V or less → 9 V or higher |
|
| ||||
| OK | ||
| ||