AIRBAG SYSTEM > DTC CHECK / CLEAR |
| DTC CHECK (USING SST CHECK WIRE) |
![]() |
Check for DTCs (Current trouble codes).
Turn the ignition switch to ON, and wait for approximately 60 seconds.
Using SST, connect terminals TC and CG of the DLC3.
Check for DTCs (History trouble codes).
Turn the ignition switch off.
Using SST, connect terminals TC and CG of the DLC3.
Turn the ignition switch to ON, and wait for approximately 60 seconds.
![]() |
Read the DTCs.
Read the blinking patterns of the DTCs. As an examples, the blinking patterns for the normal system code and trouble codes 11 and 31 are shown in the illustration.
| Number of Blinks | Indicated Letter |
| 10 | A |
| 11 | B |
| 12 | C |
| 13 | D |
| 14 | E |
| 15 | F |
| DTC CLEAR (USING SST CHECK WIRE) |
Clear the DTCs.
When the ignition switch is turned off, the DTCs are cleared.
Using SST, connect terminals TC and CG of the DLC3, and then turn the ignition switch to ON.
Disconnect terminal TC of the DLC3 within 3 to 10 seconds after the DTCs are output, and check if the SRS warning light comes on after 3 seconds.
Within 2 to 4 seconds after the SRS warning light comes on, connect terminals TC and CG of the DLC3.
The SRS warning light should go off within 2 to 4 seconds after connecting terminals TC and CG of the DLC3. Then, disconnect terminal TC within 2 to 4 seconds after the SRS warning light goes off.
The SRS warning light comes on again within 2 to 4 seconds after disconnecting terminal TC. Then, reconnect terminals TC and CG within 2 to 4 seconds after the SRS warning light comes on.
Check if the SRS warning light goes off within 2 to 4 seconds after connecting terminals TC and CG of the DLC3. Also check if the normal system code is output within 1 second after the SRS warning light goes off.
If DTCs are not cleared, repeat this procedure until the codes are cleared.

| DTC CHECK (USING INTELLIGENT TESTER) |
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON, and wait for approximately 60 seconds.
Turn the intelligent tester on.
Enter the following menus: Body / SRS Airbag / DTC.
Check for DTCs by following the prompts on the intelligent tester screen.
| DTC CLEAR (USING INTELLIGENT TESTER) |
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON, and wait for approximately 60 seconds.
Turn the intelligent tester on.
Enter the following menus: Body / SRS Airbag / DTC.
Clear the DTCs by following the prompts on the intelligent tester screen.