Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM

DTC    C1201    Engine Control System Malfunction

for Preparation Click here


DESCRIPTION

If a malfunction in the SFI system is detected, the operation of VSC and TRC is prohibited by the fail-safe function. When the signals from the engine are received normally, fail-safe control is canceled.

DTC No.
DTC Detection Condition
Trouble Area
C1201
Engine control system malfunction signal continues for 2.5 seconds.
SFI system

INSPECTION PROCEDURE

1.CHECK SFI SYSTEM
  1. Check if an SFI system DTC is output (Click here for 2GR-FE, or Click here for 2AR-FE).

    Result:

    Result
    Proceed to
    DTC is not output (for 2GR-FE).
    A
    DTC is not output (for 2AR-FE).
    B
    DTC is output (for 2GR-FE).
    C
    DTC is output (for 2AR-FE).
    D

    HINT:
    If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing parts (Click here).



B
REPLACE ECM (Click here)

C
INSPECT SFI SYSTEM (Click here)

D
INSPECT SFI SYSTEM (Click here)
A

REPLACE ECM (Click here)