POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM > DATA LIST / ACTIVE TEST |
| READ DATA LIST |
Turn the engine switch off.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Tilt & Telescopic / Data List.
According to the display on the intelligent tester, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Tilt Position | Current tilt position data/ Min.: 0 Max.: 65535 | 28672 to 36864 | - |
| Telesco Position | Current telescopic position data/ Min.: 0 Max.: 65535 | 28672 to 36864 | - |
| Tilt Return Position | Memorized tilt return position data/ Min.: 0 Max.: 65535 | 28672 to 36864 | - |
| Telesco Return Position | Memorized telescopic return position data/ Min.: 0 Max.: 65535 | 28672 to 36864 | - |
| Tilt Memory Pos 1 | Tilt data of memory position 1/ Min.: 0 Max.: 65535 | 28672 to 36864 | (This item is not related to this vehicle) |
| Telesco Memory Pos 1 | Telescopic data of memory position 1/ Min.: 0 Max.: 65535 | 28672 to 36864 | (This item is not related to this vehicle) |
| Tilt Memory Pos 2 | Tilt data of memory position 2/ Min.: 0 Max.: 65535 | 28672 to 36864 | (This item is not related to this vehicle) |
| Telesco Memory Pos 2 | Telescopic data of memory position 2/ Min.: 0 Max.: 65535 | 28672 to 36864 | (This item is not related to this vehicle) |
| Tilt Memory Pos 3 | Tilt data of memory position 3/ Min.: 0 Max.: 65535 | 28672 to 36864 | (This item is not related to this vehicle) |
| Telesco Memory Pos 3 | Telescopic data of memory position 3/ Min.: 0 Max.: 65535 | 28672 to 36864 | (This item is not related to this vehicle) |
| Tilt Up Limit | Uppermost tilt position/ Not Mem or Mem | Not Mem: Position not memorized Mem: Position memorized | - |
| Tilt Up Limit Position | Uppermost tilt position data/ Min.: 0 Max.: 65535 | 28672 to 36864 | - |
| Tilt Down Limit | Lowermost tilt position/ Not Mem or Mem | Not Mem: Position not memorized Mem: Position memorized | - |
| Tilt Down Limit Position | Lowermost tilt position data/ Min.: 0 Max.: 65535 | 28672 to 36864 | - |
| Telesco Short Limit | Shortest telescopic position/ Not Mem or Mem | Not Mem: Position not memorized Mem: Position memorized | - |
| Telesco Short Limit Pos | Shortest telescopic position data/ Min.: 0 Max.: 65535 | 28672 to 36864 | - |
| Telesco Long Limit | Longest telescopic position/ Not Mem or Mem | Not Mem: Position not memorized Mem: Position memorized | - |
| Telesco Long Limit Pos | Longest telescopic position data/ Min.: 0 Max.: 65535 | 28672 to 36864 | - |
| Tilt Up Switch | Input state of tilt up switch/ ON or OFF | ON: Tilt up switch activated OFF: Tilt up switch not activated | - |
| Tilt Up SW (CAN) | Input state of tilt up switch/ ON or OFF | - | (This item is not related to this vehicle) |
| Tilt Down Switch | Input state of tilt down switch/ ON or OFF | ON: Tilt down switch activated OFF: Tilt down switch not activated | - |
| Tilt Down SW (CAN) | Input state of tilt down switch/ ON or OFF | - | (This item is not related to this vehicle) |
| Telesco Short Switch | Input state of telescopic contract switch/ ON or OFF | ON: Telescopic contract switch activated OFF: Telescopic contract switch not activated | - |
| Telesco Short SW (CAN) | Input state of telescopic contract switch/ ON or OFF | - | (This item is not related to this vehicle) |
| Telesco Long Switch | Input state of telescopic extend switch/ ON or OFF | ON: Telescopic extend switch activated OFF: Telescopic extend switch not activated | - |
| Telesco Long SW (CAN) | Input state of telescopic extend switch/ ON or OFF | - | (This item is not related to this vehicle) |
| T&T Manual SW Data | Voltage data of tilt and telescopic switch/ Min.: 0 V Max.: 4.99 V | Neutral position: Below 0.2 V Tilt up: 1.67 to 2.13 V Tilt down: 0.54 to 0.74 V Telescopic contract: 1.08 to 1.40 V Telescopic extend: 2.22 to 2.77 V | - |
| S/B Mem 1 | Tilt and telescopic memory position 1/ Not Mem or Mem | Not Mem: Position not memorized Mem: Position memorized | (This item is not related to this vehicle) |
| S/B Mem 2 | Tilt and telescopic memory position 2/ Not Mem or Mem | Not Mem: Position not memorized Mem: Position memorized | (This item is not related to this vehicle) |
| S/B Mem 3 | Tilt and telescopic memory position 3/ Not Mem or Mem | Not Mem: Position not memorized Mem: Position memorized | (This item is not related to this vehicle) |
| T&T Autoaway Function | Auto away/return function/ ON or OFF | ON: Auto away/return function allowed OFF: Auto away/return function prohibited | - |
| Power Source Voltage | Voltage data of power supply/ Min.: 0 V Max.: 19.99 V | 11 to 14 V | - |
| Freeze Speed Info | Vehicle speed data/ Min.: 0 km/h (0 mph) Max.: 255 km/h (158 mph) | Stop → Drive → Stop | 0 km/h (0 mph) → Same speed as indicated on speedometer → 0 km/h (0 mph) |
| IG Switch (CAN) | Communication state of engine switch/ ON or OFF | ON: Communication normal OFF: Communication interrupted | - |
| IG Switch | Input state of engine switch/ ON or OFF | ON: Input signal normal OFF: Input signal interrupted | - |
| Receive from Meter | Communication state of combination meter assembly signal/ OK or Interpt | OK: Communication normal Interpt: Communication interrupted | - |
| Receive from Seat ECU | Communication state of position control ECU signal/ OK or Interpt | OK: Communication normal Interpt: Communication interrupted | (This item is not related to this vehicle) |
| Receive from Combi | Communication state of combination switch ECU signal/ OK or Interpt | OK: Communication normal Interpt: Communication interrupted | (This item is not related to this vehicle) |
| J/B | Communication state of main body ECU (multiplex network body ECU) signal/ OK or Interpt | OK: Communication normal Interpt: Communication interrupted | - |
| Driver Information 1 | Driver Information 1/ Not Mem or Mem | - | (This item is not related to this vehicle) |
| Driver 1 Tilt Mem | Driver tilt memory position 1/ Min.: 0 Max.: 65535 | - | (This item is not related to this vehicle) |
| Driver 1 Telesco Mem | Driver telescopic memory position 1/ Min.: 0 Max.: 65535 | - | (This item is not related to this vehicle) |
| Driver Information 2 | Driver Information 2/ Not Mem or Mem | - | (This item is not related to this vehicle) |
| Driver 2 Tilt Mem | Driver tilt memory position 2/ Min.: 0 Max.: 65535 | - | (This item is not related to this vehicle) |
| Driver 2 Telesco Mem | Driver telescopic memory position 2/ Min.: 0 Max.: 65535 | - | (This item is not related to this vehicle) |
| Driver Information 3 | Driver Information 3/ Not Mem or Mem | - | (This item is not related to this vehicle) |
| Driver 3 Tilt Mem | Driver tilt memory position 3/ Min.: 0 Max.: 65535 | - | (This item is not related to this vehicle) |
| Driver 3 Telesco Mem | Driver telescopic memory position 3/ Min.: 0 Max.: 65535 | - | (This item is not related to this vehicle) |
| Handle Position | Steering wheel position signal/ Away or Return | Away: Steering wheel in away position Return: Steering wheel in return position | - |
| The Number of DTCs | Number of stored DTCs/ Min.: 0 Max.: 255 | Actual number of stored DTCs | - |
| ACTIVE TEST |
Turn the engine switch off.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Tilt & Telescopic / Active Test.
According to the display on the intelligent tester, perform the Active Test.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Tilt Operation | Tilt operation | UP/DOWN | - |
| Telesco Operation | Telescopic operation | LONG/SHORT | - |